adjusting temp on maxicure

varsityink · March 12th, 2011, 05:52 PM

Anyone know how to adjust the temp on this digital control board that has an sv and a pv on it? I know I had to call on my other dryer to get it right, but I'm trying to start printing 1100 shirts right now and can't figure out how to adjust it. The temp is just a little too low...

Call me asap if you know how 678-249-4309

gotshirtz001 · March 12th, 2011, 06:57 PM

SV means SET VALUE and is what the controller is trying to maintain
PV means PRESENT VALUE and is an actual temp reading

Press the SV button and adjust the UP arrow buttons under each number to adjust
Example: Under the SV of 800, press the arrow under the 8 to adjust the hundreds.
Follow the same for each of the 0s to achieve your new SET VALUE.
You can use the DOWN arrow once the numeral has been selected if you need to decrease.

Hope this helps.

varsityink · March 13th, 2011, 02:53 PM

Haha yeah this d-amn thing is impossible to regulate when it's reading 900 degrees ++ on the thermocouple. Also sucks because apparently I have to keep the doors closed to the shop to reach temperature instead of having a cool breeze all day....