February 22nd, 2012, 08:40 AM
|
#7 (permalink)
|
Senior Member
- Join Date:
- Jul 2009
- Posts:
- 186
- Liked:
- 56 times
|
Re: Anatol Rapid Wave Flash
Quote:
Originally Posted by DesignShoppe
Trying to re-wire from 3 phase to single phase. Think this is where they don't want to send info, it was going to cost $300 to send in and get re-wired by Anatol. Local electrician says its as simple as crossing a couple wires over. Much rather buy lunch as opposed to spending $300
|
"Local electrician says its as simple as crossing a couple wires over"
Normally I run when I hear those words! It reminds me of a rednecks
famous last words " hey guys, watch this". $300 is a bargin, however I
understand money isn't found on trees. When you change 3 phase to single
phase, you are balancing the load of three lines on to two. Make sure your
wire,relays,etc. can handle the higher amperage.Have your electrician call
me, if you like. I will try and walk him thru it.
winston
904.3430848
|
|
|