February 25th, 2014, 05:35 PM
|
#2 (permalink)
|
Junior Member
- Join Date:
- Dec 2013
- Location:
- Tampa Florida area
- Posts:
- 1
- Liked:
- 1 times
|
Re: ?check stitch count on my ESP9000
Checking the total stitch count on a Toyota EMB 9000.
Warning: Turn the machine off before setting Test Mode:
You should read the entire process before beginning.
1. Turn the machine off.
2. Access the dip switches on the control module.
On my machine, I took a screw off of the back of the module.
3. Insure the machine is off!
Set the bottom switch to the right most position.
(DSW1-1 only to ON)
4. Turn the machine back on.
The machine should now show TEST MODE on the display.
5. Press the SET key.
The machine should now show Test menu with #1 = Panel.
6. Press the SET key again.
The machine should now show Panel menu.
7. Navigate to the MAINTENANCE selection (#5).
8. Press the SET key again.
This selection should yield an encoded value:
XXX YYY ZZZ
where:
XXX = billions
YYY = millions
ZZZ = thousands
The number is displayed using a ‘CHARLESTON’ code, where
C=9, H=8, A=7, . . . O=1, and N=0.
i.e., the code: NNN NTC ERL == 29,465,000 stitches to date.
9. Write down the displayed value.
10. Turn the machine off.
11. Set the bottom switch to the left position.
(DSW1-1 to OFF).
12. Replace the dip switch cover.
13. Translate the encoded number to find your total stitches.
Viola -- you have your total stitch count to date.
Hope this helps.
p.s. I've attached a word doc with this procedure (I think).
|
|
|