August 14th, 2014, 03:59 AM
|
#1 (permalink)
|
Junior Member
- Join Date:
- Aug 2014
- Posts:
- 2
- Liked:
- 0 times
|
Does anybody have a SWF/AT-1201 too?
I have a SWF/AT-1201. The thread was not cut good enough on mine. I just purchased a new fixed mes (under the needle plate). I'm facing now some difficulties to screw the new one. I should place it on the right side, but I have a cable going to the sensor pin system at the same side. there is not enough place for the fixed mes and the cable if I want to screw the needle plate back. I don't remember how it was before moving the old fixed mes ! Please, can anybody post a picture of it on the same machine to show how it should be ?
|
|
|