August 23rd, 2011, 06:20 PM
|
#1 (permalink)
|
Junior Member
- Join Date:
- Aug 2011
- Posts:
- 2
- Liked:
- 0 times
|
EMC 6/4 problem, Need Tech
I can't get the x & y drive motors to ingage. I was told it was the Motor Driver interface PCB , So I sent the PCB to florida to have it checked and repaired, I got it back, installed it and there is no change. I have checked the voltage on the PCB TP4-24B has 24 volts but the TP3-24A has no volts at all, I have checked all the conections,plugs and wires with no obvious problems.I was hoping someone can help.
|
|
|