March 19th, 2014, 03:08 PM
|
#5 (permalink)
|
Junior Member
- Join Date:
- Mar 2014
- Posts:
- 1
- Liked:
- 0 times
|
Re: How to emb on a 4x4 hoop to make a 8x10 design
You have to separate the design into separate hoop-able elements. print out a copy of each design scale to actual size then position the paper copies with the one on top of the other with the over overlapping section aligned as needed. The center of the design (of each overlapping section) is the needle start position. Hoop the first part and draw a level line with a washable pencil.Run the first design.Set the paper for the second design, using the level line as a guide. Hoop the second design align to your level line and set the needle to the center of the paper copy. the second design will run from center and overlap where you set the original design. Since you leveled at each set the alignment should be very close if not perfect.
|
|
|