DigitSmith

Issue With Roland Camm-1 Comunication.. Help!!??

Reply
 
Thread Tools Search this Thread
Old June 2nd, 2008, 01:46 AM   #1 (permalink)
wildchildc1 wildchildc1 is offline
Junior Member
Join Date:
Jun 2008
Posts:
1
Liked:
0 times
Default Issue With Roland Camm-1 Comunication.. Help!!??

I have a Roland Camm-1 PNC-1000, I do not have a manual and have been unable to locate one online. If I use a 25 pin terminal cable on the PC and the larger printer port on the cutter I can get it to spool up and print some type of code when I hit the plot button, but it will not cut what is on the screen. I was told I needed a 25 - 25 pin cable but I have this and have tried all the settings and numerous drivers with no luck, it does nothing. I really need help getting this up and running since my primary machine needs to go in for service. I would really apprerciate help and ides if you have them??!! Thank you, Shawn
Send a private message to wildchildc1 ContactReply & Quote
Reply

Thread Tools Search this Thread
Search this Thread:

Advanced Search


Similar Threads
Thread Thread Starter Forum Replies Last Post
Polyester bleeding (sublimation) issue jr_sanford Screen Printing 5 February 5th, 2009 05:06 PM

All times are GMT -4. The time now is 06:55 AM.
Copyright © 2011 DigitSmith. All rights reserved.
Forums software by VBulletin, Copyright © 2000-2019, Jelsoft Enterprises Ltd.
Content Relevant URLs by vBSEO ©2011, Crawlability, Inc.