March 7th, 2013, 07:34 AM
|
#1 (permalink)
|
Member
- Join Date:
- Apr 2011
- Posts:
- 52
- Liked:
- 4 times
|
Little Help Please!!
One of our machines is doing something I've never seen before. It's a 1989 TME HC 912 Tajima that is close to needing a complete overhaul, but it still runs, so I run it. I have one head where the #2 needle sews just fine, but at any, ANY stop (thread break, manual stop, bobbin sensor, etc.) the needle bar drops the presser foot to 1/4" off of the plate! Timing is good, the thread take up lever is at top deadcenter, and the reciprocator is in proper position and acts properly with good spring action.
I am stumped. Any ideas guys?
Thanks
Jamie
Artex Knitting Mills
Union Made in the USA and PROUD OF IT
|
|
|