May 16th, 2011, 03:43 PM
|
#1 (permalink)
|
Senior Member
- Join Date:
- Feb 2010
- Posts:
- 133
- Liked:
- 2 times
|
Machine Not Zeroing Correctly
Hi Folks,
Tony again.
I recently replaced the X limit sensor in y Toyota 850. In the process, I had dissconnected the Y sensor to check it. The tech had me do this. Now when I initialize the machine, my zero point is way off on the Y axis. The X axis is ok. If I have to shut down in the middle f a job. I have to reinitialize at start up and it does not go back to the same point as it should when continuing the embroidery. It ends up at a different spot.Any ideas on how to reset the zero on this thing.
Tony
Twin Dragon Embroidery
|
|
|