Melco EMT 10T

dmr338

Just bought a melco emt 10t and design shop V9.

I am unable to link my melco to my computer to send designs. Any suggestions?

lulu2222

You have to load designs with the OS software.

bigmacatac

a standard cat5 or cat 6 cable directly from the network port on the computer should connect directly to the machine. you need to go into ENS and look under the status tab to make sure your machine is being "Seen" by the computer. if not you could have a bad network port on either the computer or EMT. EMT's were designed to be networked through a hub if you have more than one.

tyger777

Hi I have a EMT10 if you cant use it with the computer then just copy the designs to a floppy disk and put it in the machine hope this helps