December 18th, 2010, 06:36 PM
|
#4 (permalink)
|
Member
- Join Date:
- Sep 2009
- Posts:
- 79
- Liked:
- 3 times
|
Re: Need help with TEHX C-1501
There are only 2 causes for this error:
1) EStop interlock. Depress EStop button and release E-Stop state. If not.
2) Try checking your light sensor. All Tajima machine come with a light sensor to prevent pinching your fingers with needle while machine runs. There is a beam light sensor mounted on the right side of machine and the reflector is on the left side, make sure they are facing each other perfectly. To verify it, adjust them first and place your hand in the middle of them and see lights going either on or off on top of sensor. once is adjusted and working you should be fine.
3) If this does not fix it then sensors are either disconnected or cables pinched, this might happened during transit.
Good luck!
|
|
|