DigitSmith

Roland Camm-1

Reply
 
Thread Tools Search this Thread
Old August 14th, 2006, 06:53 PM   #1 (permalink)
woodward woodward is offline
Junior Member
Join Date:
Aug 2006
Posts:
1
Liked:
0 times
Default Roland Camm-1

I bought a roland camm1 second handed. I don't have a manual, I looked at the one that is online but it does not answer my question. Please help. When I try to cut, it gives me the following error:
err bad position.

I realize that it also will give you this if you do not have the eye covered but it is covered.

I hope you can help.
Thanks
Send a private message to woodward ContactReply & Quote
Old November 15th, 2006, 08:05 AM   #2 (permalink)
Bob Robinson Bob Robinson is offline
Junior Member
Join Date:
Nov 2006
Location:
southwest PA
Posts:
1
Liked:
0 times
Default Re: Roland Camm-1

Bad position usually indicates that the pinch rollers are not on the grit rollers . These are indicated by the white rectangles above.
Send a private message to Bob Robinson ContactReply & Quote
Reply

Thread Tools Search this Thread
Search this Thread:

Advanced Search


All times are GMT -4. The time now is 04:54 PM.
Copyright © 2011 DigitSmith. All rights reserved.
Forums software by VBulletin, Copyright © 2000-2019, Jelsoft Enterprises Ltd.
Content Relevant URLs by vBSEO ©2011, Crawlability, Inc.