Screenjet CTS / DTS imaging system + MSP3140 Exposure Unit

Admiral

This is currently in use but will be available early to mid November. We are upgrading to a larger CTS unit to do our 25x36 screens as well as 23x31.

This uses water based ink from an Epson head to print directly on the screen. It fits up to 23x31 screens (we only do 23x31 screens on it). To do other sizes, other jigs will need to be made or ordered to fit those screens in the system. There is one small issue currently with the CTS that we are working on fixing, the screen pops back out when first sent in to be printed but then prints fine afterwords. This should just be a sensor issue. We do several hundred screens a month on this machine just fine.

The MSP3140 had it's blanket replaced recently since we started using it again with glass to do 25x36 screens. With Screenjet imaged screens we of course don't need the glass or vacuum, the exposures instantly go on with this unit with no vacuum going since we preset it to 0 vacuum.


We are asking 25K for the CTS and exposure unit together.







MSP3140

Attached Thumbnails

 

Admiral

This will also include the RIP and workflow software that came with the machine, Xitron software, uses a USB dongle for the license.

Admiral

Price drop to 23K

Admiral

Bump

Admiral

Bump, new CTS is installed this week, then we will just run this a couple times a week to keep it running fine.

Admiral

Bump, new CTS up and running. This one only for a few screens a week until we sell it.

JohnG

Did you fix the problem with the sensor?

Admiral

Unfortunately no, we will be selling it like this. It adds 20 seconds or so to imaging each screen.

Taking offers.

Admiral

Bump

Admiral

Separating the equipment since there was interest in just the CTS alone from multiple people.

Screenjet CTS - $18K
Nuarc MSP3140 - $1200