Sublimation coater needed

rdtagman

I have a requirement to have some aluminum plates (12" x 16" x 1/16" ) coated for sublimation. Can someone point me toward a shop that does the actual coating? I had rather not go through a dealer on this product, but an actual coating shop.

MichalD

We are a well-known Polish producer of articles for printing. We offer a wide range of range for printing. The first department of our production are heating presses for sublimation transfer. For several years we developing chemical production. After cleaning fluid for sublimation ink, ink for direct printing on textile, we start to work on special lacquer for sublimation. After years of research and testing we are proud to offer our new product - SUBLI-PRIME. First, fully water based lacquer for sublimation process.
We do not use heavy solvant like xylen, etc, used in other lacquer for sublimation. Ours solvant is water! Lacquer do not need any UV curing lamp, do not need any pre heating process. Lacquer do not need any hardener, or two component.
With ours lacquer is possible to prepare own substract and media for sublimation. Puzzle, ceramic, glass, etc, can be prepared from raw materials, avoiding expensive purchases of ready media for sublimation. Prepare yours own media, in very attractive price (min. 200% cheaper that ready) when You want and when You need. Start to print on wood, metal, marble, mirror, etc. Using Your imagination!

Mainly information about lacquer:

1. Working on almost every substract (glass, carton, stone, paper, marble,
ceramic, metal, wood, brix, etc), with speciall version for cotton (this
will be in january),
2. Fully transparent, gloss (also possible to make matt or satin version),
3. Not yellowishing on high temperature,
4. Colour after transfer are sharp, vivid, we can say that even better with
lacquer that without,
5. Water based, so not dangerouse for health and enviroment
6. Not flammable
7. Without bad odour
8. Giving also extra protection on UV (we can do also better version for UV
resistant), printout are longer in good condition
9. Scratch resistant and adhesion in good level (depending on media)
10. Do not need a lot of experience, with perfect flowing parameters You can
obtain good, shiny resultat, without and defect
11. Not need heavy investment on tools, vacum, etc.
12. Easy to use with paitn brush, roll, sponage, air gun, etc.
13. Do not need any UV curing
14. Do not need any hardener, like second component
15. Do not need to use oven like preheating process - simply after drying is
ready to use.
16. With certificate of National Institute of Hygiene
17 Good also for small bussines and end-user, it easy to work and do not
need investment, cost, etc.
18. For speciall order we can do also version water proof, and dust
reppelent, anti dirty - printout will be longer clean outside,and to is just
water