December 18th, 2009, 10:59 PM
|
#3 (permalink)
|
Member
- Join Date:
- Oct 2009
- Location:
- California
- Posts:
- 46
- Liked:
- 4 times
|
Re: sweatpant printing help
GW,
Watch your heat...just flash enough to make tacky...
Spray lots of adhesive....
These 2 things will help your sweats not move out of reg.
Now for your sizing...its up to you.
If you want to use your sleeve platen then under 4 probably. I just did a big run in the same location using my youth pallet. I made sure my design was over from center, and made sure the pockets were pulled out...and out of the way.....Ended up just the way we planned. We went 5.5 inches on that design and was perfect. Ours was a different shape of a design...but I would say on yours about 5-6 inches tall.
Off contact will need to be adjusted higher.
And looking at your design I would use a 230 base screen and 156 for the other 2 colors to go on top.. On an auto..
Jon
|
|
|