Tajima TEHX error code

rbforrest · October 24th, 2011, 01:45 PM

Help! I was oiling the tajima this morning and unknowingly did something to casue an error. The error code is 211 and according to the book the "stop factor" is "a fixed position signal is not detected. (Main shaft Z signal)". The "corrective action is "return the main shaft to the fixed position".

Any ideas as to how I can do this?

Thanks

Robert Young · October 24th, 2011, 02:16 PM

on the side of your machine do you see a wheel with numbers on it? if so then turn that wheel to where the arrow is pointing to the numbers that are within the area marked in the color RED.

dgeorge · October 24th, 2011, 02:52 PM

first reset the error
try to perform an manual trim

rbforrest · October 24th, 2011, 03:03 PM

I fixed it. Just ran the ATH process and it picked up fine.
Thanks

angeldancer247 · March 17th, 2016, 10:42 AM

Quote:

Originally Posted by rbforrest

I fixed it. Just ran the ATH process and it picked up fine.
Thanks

Hi. Could you tell me how you ran the ATH process? I cannot make my machine do much right now and I have an order I have to get out by tomorrow. I'm really stressing it right now! Thanks!

dgeorge · March 17th, 2016, 03:29 PM

press D button till you will see M ATH.
turn the JOG DIAL (the wheel on the right up side) to have circle on the screen(M ATH o).
press SET.
the machine must prforme trimm.
this is for STANDARD panel.

angeldancer247 · March 18th, 2016, 01:12 PM

Man, that's what I thought. It is not working for me. :-( thanks

dgeorge · March 22nd, 2016, 03:53 AM

try to do what Robert Young said and press SET.
start the machine.
work or not?
the shaft turn?