February 14th, 2012, 04:01 PM
|
#1 (permalink)
|
Member
- Join Date:
- Nov 2009
- Location:
- Washington State
- Posts:
- 45
- Liked:
- 0 times
|
Thread not trimming properly
I have two questions about the machine not trimming thread properly:
1) One head on the machine trims the thread, but it doesn't trim it clean right up to the fabric, so there is about an inch of excess thread after the trim. What is causing this? Also, when I remove a garment from the machine, the bobbin isn't trimmed. Are these two problems related?
2) I don't know the name of the parts, but there is one head that doesn't seem to be trimming at all. There is a little blade that is supposed to trim from underneath, and I don't believe it is moving or engaging, and therefore isn't trimming the thread. When the arm comes down from behind the needle, it doesn't grab the thread but I think it is because the blade isn't working as it should. Can I fix this somehow?
Thanks!
|
|
|