DigitSmith

Trimming Error

Reply
 
Thread Tools Search this Thread
Old July 29th, 2015, 07:12 PM   #1 (permalink)
CSP CSP is offline
Member
Join Date:
Dec 2010
Location:
San Jose, Ca
Posts:
40
Liked:
0 times
Default Trimming Error

Hi to all, I have a Toyota AD860 and get a trimming error at every trim. I have to stop then start every time but the thread is getting trimmed. I have to pull the thread out every time almost like it's being trimmed too long but it's trimming. The manual says that the thread is either too thick or the blades need replacing, but it's getting trimmed. Anyone experience this or know the cause and fix? Thanks!
Send a private message to CSP ContactReply & Quote
Old July 29th, 2015, 08:08 PM   #2 (permalink)
CSP CSP is offline
Member
Join Date:
Dec 2010
Location:
San Jose, Ca
Posts:
40
Liked:
0 times
Default Re: Trimming Error

Ok, after watching videos of other toyota machines I realized there's a hook that comes down to pull the thread out of the garment. That hook doesn't come out on my machine. Could it be stuck? Missing? Where do I look for it? I just got this machine so I didn't know about it. Thanks.
Send a private message to CSP ContactReply & Quote
Old August 13th, 2015, 05:28 PM   #3 (permalink)
rtfulk rtfulk is offline
Junior Member
Join Date:
Aug 2007
Posts:
20
Liked:
0 times
Default Re: Trimming Error

On your left hand side just behind the needles and at about a 45degree angle. You will see a bolt (mine is Black) and it is on a metal track. Slide the bolt down, that is what the hook attaches to. The hook is a thin metal and more than likely got bent and won't come down. If that's the case then gently bend the hook so it will move up and down the slide freely.
Send a private message to rtfulk ContactReply & Quote
Old November 5th, 2015, 10:34 PM   #4 (permalink)
onet onet is offline
Senior Member
Join Date:
Dec 2008
Location:
alberta canada/ seattle washington
Posts:
201
Liked:
3 times
Default Re: Trimming Error

Did you get this issue sorted?
__________________
Send a private message to onet ContactReply & Quote
Reply

Thread Tools Search this Thread
Search this Thread:

Advanced Search


Similar Threads
Thread Thread Starter Forum Replies Last Post
needle change error dubiat Embroidery and Digitizing 12 July 6th, 2017 03:50 PM
HELP with new Tajima Neo Plus Machine - Error Code 293 kohnan Embroidery and Digitizing 4 February 25th, 2016 03:23 PM
Shaft sensor error noempty Embroidery and Digitizing 0 July 18th, 2012 08:49 PM
Tajima Main Shaft Motor Control Box "E2" error please help solimar cancun Embroidery and Digitizing 1 December 18th, 2009 07:56 PM
SWF / Trimming Error 103???? What? Anyone Know? SDEmbroidery Embroidery and Digitizing 2 October 19th, 2009 12:53 PM

All times are GMT -4. The time now is 02:26 AM.
Copyright © 2011 DigitSmith. All rights reserved.
Forums software by VBulletin, Copyright © 2000-2019, Jelsoft Enterprises Ltd.
Content Relevant URLs by vBSEO ©2011, Crawlability, Inc.