October 7th, 2012, 05:46 PM
|
#2 (permalink)
|
Member
- Join Date:
- Apr 2010
- Posts:
- 56
- Liked:
- 24 times
|
Re: Workhorse pq3011
Tough question. Basically you want the ink to hit 325F all the way through. so 325F for 90 seconds is a good starting point, as long as the temperature readout is accurate on your oven. After that you can experiment with higher temps for shorter times. If you under-cure, the ink with partially wash-out and/or crack when stretched. Over-curing can cause the ink to get a bit brittle too.
The best test is a doughnut temp probe buried in the wet ink and sent through the oven to measure temp inside the ink layer. many just get by with a point and shoot temp gun checking the temp of the print right near the end, but still inside the oven.
|
|
|