Finally I’m trying to do some digitizing with my PE Design software which I was so excited to purchase but I quickly lost interest when I first installed it, it looked scary and hard!!! So now I’m all excited again cause the holidays is just around the corner and I want to digitize simple things for my visiting little munchkins. I’ve already purchased some tutorials and now I’m getting comfy with it. My tip of the day is to use Layout and Editing if you want lots of control rather than DC. I always use Layout and Editing now!
I also only use L&E. Good luck on learning digitizing.
I’m thinking of getting PE Design because my dealer recommends it also. Thanks for the tip.